Heat pump DAIKIN ALTHERMA 8.0 kW with 180L boiler (08S18E6V-E9W/08EVH)
Floor air-water heat pump for heating, cooling and hot water; ideal for low energy homes
➢ Heating, cooling and hot water preparation.
➢ COP up to 5.10
➢ The outdoor unit works up to -25°C outside air temperature
➢ Easy and quick installation
➢ Built-in stainless steel tank 180 or 230 l
➢ All in one, contains the tank and components necessary for heating
➢ Special design of the outer part - no bottom heater is required
➢ Built-in WiFi controller for remote control
➢ Simple and friendly management in LV and RU
Why choose Daikin Atherma 3 with integrated hot water heater?
The best efficiency results in the greatest savings on operating costs. The Daikin Altherma 3 integrated heat pump is an ideal solution for new buildings as well as low-energy houses. Daikin's Bluevolution technology combines highly efficient compressors with a refrigerant: R32.
Sanitary water cooling and heating with one device
Maximum safe and economical operation
The heat pump heat exchanger for heating sanitary water is located outside the heater and is not in direct contact with sanitary water. The advantage of this construction is that it is completely protected against possible mixing of sanitary water and refrigerant. A heat exchanger with an increased transfer surface further contributes to the efficiency of the heat pump. The result is maximum safe and economical operation.
All in one system saves space and time during installation
The floor area of the integrated indoor unit is only 600 x 600 mm, which is similar to other household appliances such as a refrigerator. Installation requires almost no additional space on the sides, as the piping is located on top of the unit. The installation height is 1.65 m for the 180 l heater and 1.85 m for the 230 l heater, so the required installation height is less than 2 m. The small size of the integrated indoor unit is further emphasized by the sleek design and modern appearance, which blends perfectly with other household appliances.
Smart management
The heat pump signal shows the system status in real time. Blue means the system is working perfectly, if the eye turns red, there is a failure. With the MMI Setup Assistant, you can configure the operation of the device in less than 10 steps. By performing test cycles, you can check the readiness of the device for use! The high-resolution color display provides excellent visualization of system performance, giving the user or technician a truly easy overview of pump performance.
